The bathroom is the place where it is used most often, so it is always super-hearted during the renovation, and everything is considered everywhere. But after checking in, you will find many blind spots that are not considered, such as the outlet is not enough, the shower height is not right, and so on. At the beginning of the full expectation, there is only regret and helplessness.

First look at the waterway

The bathroom is the place with the most water, so the design of the waterway must be considered clearly before the renovation, and planning should be done. In order to avoid the situation of insufficient use after check-in. Here I have a simple list for everyone, you can refer to it, of course, you can adjust according to your actual situation.

1. Washing machine faucet (1)

2. Mop pool faucet (one: Although many families are uneasy to mop the pool when renovating, it is best to install a faucet for cleaning rags, etc.)

3. The water inlet and outlet of the water heater (a group: tell the truth, this must be)

4. Toilet interface (one)

5. Hot and cold water outlets of the washstand (2)

6. Water floor drain (two)

Circuit cannot be ignored

Circuits have always been the top priority in the renovation. With the increasing number of home appliances, the demand for circuits is increasing, as is the bathroom. In the decoration, you can reserve a socket next to or behind the toilet. This is mainly because you can use the smart toilet in the future. You can also install a socket next to the sink. You can use it as a hair dryer. Of course, the position is not absolute. Fixed, can be adjusted according to personal habits

As for the switch of the water heater, it is better to make the control of the switch panel, so as to reduce the extra loss caused by the plug; finally, it is recommended that the main lamp and the exhaust fan switch of the bathroom be designed outside the door of the bathroom. In addition to hydropower, there are some other things that need to be taken care of in the renovation of the bathroom. Here I also pick some important things for everyone.

The hand basin and the toilet water pipe should be equipped with angle valves (the angle valve can effectively adjust the water pressure, and can also play the role of a switch. If the faucet leaks, etc., the triangle valve can be turned off, it is not necessary to close the main valve in the home) Check in after check-in.

When installing the exhaust fan, pay attention to observe whether the exhaust pipe and the seal are installed. This step is essential for the bathroom decoration, so as to prevent the smell from being scattered in the home. Many families found that after a period of stay, the water leakage from the floor drain was not smooth and could not be effectively drained. This is because the flushing test was not carried out after the installation of the floor drain, and the worker master may accidentally drop the cement into the sewer during the installation process. It takes a long time to solidify, causing the water to clog. Therefore, after installing the floor drain, you must immediately do a flush test to avoid such a situation.

I am talking about the floor drain. When designing a floor drain, it is best to position it in the middle of your four tiles. Not only can you make beautiful cuts, but you can also drain the four tiles with natural slopes to avoid water accumulation on the walls.

When installing the water heater, avoid the cutting brick. If the water heater is not only unable to be installed and it is very difficult to modify in the future, it is necessary to reopen the ground and the wall surface, which is time-consuming and labor-intensive.

Finally, each household has different living units and living habits. The above is just a reference and can be adjusted according to its own situation.

Ungroup

Ungroup,High Quality Ungroup,Ungroup Details, CN

Ningbo Wason Lighting Technology Co.,Ltd , https://www.wasonlights.com