The embedded bathtub can effectively expand the home space, but the embedded sanitary ware has a big difficulty, and the later maintenance and handling are more difficult. Grasping the detailed installation steps of the embedded bathtub is essential for creating a comfortable bath. Xiaobian specially brings you the detailed installation of the embedded bathtub. It is so simple to enjoy the comfortable bath!

First, install the embedded bathtub precautions

1. The low wall around the bathtub or the ribs should have sufficient supporting force, and the surrounding sand should be compacted and compacted;

2. Do not use brick or other hard objects to support the bottom of the bathtub to avoid damage to the glaze during use;

3, the bottom of the bathtub and the four peripheral corners should be in full contact with the force;

4. Note that the joints of the overflow pipe and the drain pipe are tightly connected;

5. Leave a water inspection port when you apply the tile. In order to look good on the surface, you can use glue to stick the tile on the inspection port, so that it can not be seen from the outside, and it is convenient to remove the tile during maintenance;

6. Install the water fittings before placing the bathtub, and do a 24-hour water shut-off test to see if there is water leakage at each joint;

7. When placing the bathtub, note that the end of the drain is slightly lower than the other end. The outer end is slightly lower than the inner end;

8. The actual size of the bathtub may not be exactly the same as the nominal size. When purchasing and installing, first measure it on site and reserve normal tolerances for easy installation.

9, the lower pipe is preferably slightly inverted s type, this can prevent back odor.

Second, the embedded bathtub installation method

1, preparation work

We have to choose the appropriate bathtub according to the size of the bathroom in advance, and do not look at what products look good to buy back. Secondly, we should pay attention to leaving other spares in the bathroom so that we can place other furniture in the future. Finally, we are ready to install the wrenches, wires, bricks and tiles necessary for the built-in bathtub.

2, method steps

The installation of the embedded bathtub should take into account factors such as load bearing, waterproof, maintenance, aesthetics, and performance. Most of them are at the end of the bathroom. Specific steps:

(1) After the pipeline is completed, make up the grooved part for waterproofing, and the 24-hour water storage test to ensure no leakage.

(2), we first build a contour with brick cement, paste the tile on the outside of the skirt, and build a platform with tiles in the outline.

(3), use a foam brick to pad the bathtub, the height of the bathtub is generally within 600mm. Connect the water to the water and keep it open. Then use a foam brick to build a wall plaster. Be careful to leave the inspection hole at the corresponding position of the down pipe, about 250x300mm.

(4) Next, when the cement is dry, after the stabilization, we will connect the embedded bathtub sewer pipe, and the point-to-point jam can be inserted into the pre-built contour.

(5), what materials are used on the table, you can use the same type of wall tiles, mosaic, artificial stone, marble, stainless steel, etc., depending on the style you like.

(6), the glass embedded on the wall of the embedded bathtub installation can effectively prevent the bottom from being wet, which can effectively extend the service life of the bathtub.

Moving Beam Light

Moving Beam Light,Sharpy Beam Light,Mini Sharpy Light,Sharpy Beam Moving Head Light,Led Sharpy Light

Big Dipper Laser Science And Technology Co., Ltd , https://www.bigdipper-laser.com