1. The generator set test factory can measure basic functions such as generator steady-state three-phase voltage, current, active power, reactive power, apparent power, power factor, frequency, running time, etc.
;
2. The generator tester has a harmonic analysis function that can analyze the voltage and current at the same time.
2~50th harmonic content and total harmonic content; energy accumulation function:

3, generator setting test, fluctuation test, transient test (load sudden increase, load dump unloading) function, can automatically test the load change, the maximum voltage, minimum, current, maximum, minimum, frequency, maximum, minimum, and recovery time;

4, has a strong voltage recording function, and then equipped with optical isolation
RS485/RS232 serial port communication function, powerful serial port
;
5
Not only can we measure all steady-state parameters, but we can also measure sudden and sudden discharge, voltage, current, and frequency curves, as well as voltage and current harmonic curves and harmonic content.
;
6
In combination with the host computer, basically all the electrical parameters of the generator can be measured. Automatically generate various charts, curves, and test reports. Standardized operation, strong authority. Rich data content, report applicability, and signatures, format changes, etc. based on user needs
;
7
,

Generator set test factory has 4 groups of load control functions, each group can control
25% load can be combined into
25%, 50%,
75%
100% four load types or set according to your needs;

8, load control function, can complete the sudden increase load, sudden discharge function;

9, with load-sensitive or capacitive load function (according to user needs, separate design);

10, the above control can be automatically controlled by the computer, but also on the panel manually control;

11, equipped with three
4-20mA interface, convenient to display the ambient temperature, humidity, atmospheric pressure measurement, display and upload (users configure the sensor);

12. Generator set has large test power, single
500kw, parallel to the machine
2000kw (Leading in China);

13、Optimize segmented power input mode, easy to set up, cover all power values
;
14
Fully intelligent control, completely out of manual operation. It can automatically test various parameters of generator sets including dynamic parameters, and provide scientific detection means for high-power generator sets (first in China).

15, cooling method: air-cooled;

16. Test method of generator set test: Load segment control (single-pole double-throw switch control contactor method). Can meet any set of power within the rated power combination.