Relationship between physical properties of wool and temperature and humidity

To determine the temperature and humidity requirements of wool mills, it is necessary to study the relationship between physical properties of wool and temperature and humidity. After the water content increases, the gold is softer and easier to extend into the river, but the strength is reduced, which is the difference between the animal fiber and the natural growth of the plant fiber:
The friction coefficient of the wool and the backwards of the scales are large, and the number of rubbing in the reverse direction is large. In order to facilitate the removal of impurities, the bristles have a hair opener in addition to this task, and the relative humidity is controlled to be smaller. In the mixing machine with the wool and spinning mills, the friction coefficient of the wool is reduced to facilitate the carding and spinning, and usually the oil is supplied to the wet.
When the wool is dry, it is similar to the vegetable fiber. It is a good conductor. Its conductive properties are more important than synthetic fibers such as nylon, polyester, polyester, etc., but it is more serious than the small bundle of cotton fibers. The moisture content has a significant impact on the electrical conductivity. Generally speaking, under the condition of 3% to 16% of the burr of the leather, the moisture regain of 2% can make the co-conductivity, and the static phenomenon is a relatively difficult problem. Less static phenomenon, Chen J' want to maintain a high degree of skin to keep the wool to the rate of return of the esophagus, but also should be the machine to smash the ground, so that the static electricity is easy to go underground, to prevent the wool from static electricity and draw around the cylinder Years old. In the woolen mill, the hairdressing machine is used to comb the other tops (in the combing and combing workshop), and the KT is combing the small static electricity caused by the friction, which makes it easy to send a suction and pull phenomenon* due to the W blade; It is required to have a relatively high humidity in the village of the workshop to increase the electrical conductivity of the kilo-wool. And see the wool is softer * is conducive to combing and umbrella extension. In the past few days, some factories have been working on the static elimination device of the red-packing factory on the combing machine. The effect is even better. The smoothing of the blade is smooth and uniform, and the rust is also difficult to remove the impurities.
The relative oiliness of the wool mill is generally larger than that of the cotton mill. The wool has great hygroscopicity, and the recorder shows that the wet adhesive roller and the old age are not easy to occur, and the control is relatively large compared with the leakage. It is beneficial to eliminate the flexibility of the motor to keep the fiber, and the woolen factory helps the top. And roving hemp is the detection of the wool and roving at the warehouse to allow for the addition of twists, to eliminate static electricity and eliminate the elastic wave process of the fiber process. And the wool can enter the front spun N and the roving crepe into the spun yarn.]: The art process can rarely reach the process of less serving, which is conducive to the quiet and dissipating generated by the small process. When the fiber city is "inside the tenth", the fiber inside the fiber is good for the wetness of the j-guide, and the outer ten is smooth, and the small roller is wrapped around the rubber roller to reach the yarn of the yarn. n', in the post-spinning of the wool factory, the inner sputum is less sturdy, the strong person is low, so the buckle is more control over the humidity and the control within your standard. More information: Recorder http://