Advance plastic dryer features big introduction
I believe that everyone is no stranger to the baler, then you have problems when using the baler. Do you know how to solve it? First: the cassette processing, when the belt is stuck in the middle of the roller, or there is a foreign object plugged and cannot be taken out, the treatment method is as follows: disassemble the pad of the hex nut; loosen the two M5 countersunk screws on the intermediate connecting shaft, due to The two screws are fixed on the notched part of the connecting shaft, so the screw must be turned up; remove the connecting shaft, pick up the upper machine, take out the stuck object; assemble and restore according to the above cba method. Second: the baler does not automatically take out the belt. In this case, first check if the “outlet belt length adjustment†is at “0â€, and then see if the belt is in the correct process. If not, the foreign belt is stuck near the belt pulley. This situation is caused. Third: Do not cut the belt after tightening. There are many situations that will cause this situation: the tightness adjustment is too tight; the sliding sheet or the slip belt has oil, which is located near the elastic adjustment, must be removed and wiped off the oil; the belt is too tight, will Lower the belt drive seat down, or adjust the motor to the rear; use a thinner belt or the retracting roller too much clearance. Fourth: poor adhesion: the temperature is too high or not enough, sometimes the special tape, the viscosity is poor, the temperature must be very accurate; the micro-fan of the exhaust smoke is faulty, making the temperature too high. Led Emergency Lamp,Acousto Optic Alarm,Led Light Indicator,Ouble Directions Explosion Proof Light Henan Idui Import and Export Trade Co., Ltd , https://www.acesunraylight.com